JUKI FX-1R User Manual

FX-1/FX-1R Maintenance Manual
W3 Not used.
SW5 Not used.
W4 C.OUT2 SENSOR Delay time hardware control ON/OFF
Short-circuit OFF
Open ON
SW4 C.OUT2 SENSOR Delay time setting
1 Basic clock x 1
2 Basic clock x 2
3 Basic clock x 3
4 Basic clock x 4
W5 OUT SENSOR Delay time hardware control ON/OFF
Short-circuit OFF
Open ON
SW3 OUT SENSOR Delay time setting
1 Basic clock x 1
2 Basic clock x 2
3 Basic clock x 3
4 Basic clock x 4
W6 WAIT SENSOR Delay time hardware control ON/OFF
Short-circuit OFF
Open ON
SW2 WAIT SENSOR Delay time setting
1 Basic clock x 1
2 Basic clock x 2
3 Basic clock x 3
4 Basic clock x 4
W7 IN SENSOR Delay time hardware control ON/OFF
Short-circuit OFF
Open ON
SW1 IN SENSOR Delay time setting
1 Basic clock x 1
2 Basic clock x 2
3 Basic clock x 3
4 Basic clock x 4
W8 Not used.
W9 Not used.
W10 Basic clock setting * Setting is not needed.
1-2 20 ms Pattern is short-circuited.
3-4 160 ms
5-6 80 ms
7-8 40 ms
9-10 20 ms
13-7-3. Adjusting the Stepping Driver
A stepping motor is used for the support table motor and center motor of the transport unit, and the
automatic PWB width adjustment motor.
To correctly perform the SSC-NET II communication, it is necessary to set driver axes.
Additionally, the driver of the support table motor needs the settings to correctly detect the rotating
direction.
13-29
Rev. 2.00

JUKI FX-1R Specifications

General

Brand	JUKI
Model	FX-1R
Category	Industrial Equipment
Language	English