JUKI FX-1R User Manual

FX-1/FX-1R Maintenance Manual
5-3. Replacing the IN and OUT Motors
(1) Disconnect the connector of the motor relay cable.
(2) Loosen the set screws fixing the motor bracket A to detach the drive belt from the motor pulley
A.
(3) Detach the motor and gear head.
(4) If you have detached the motor pulley A from the gear head, install a new motor so that the end
of the motor (gear head) shaft sinks below the end of the motor pulley A.
A = 6.5 mm ± 0.2 mm
IN MOTOR ASM: E9454729MA0
OUT MOTOR ASM: E9456729MA0
Figure 5-3-1
5-3
Rev. 2.00

JUKI FX-1R Specifications

General

Brand	JUKI
Model	FX-1R
Category	Industrial Equipment
Language	English