H 3
0505.USA
2.1 Crane points
The crane points (1) are the eyes in the mast.
The crane points (5) are located on the side of the chassis and crane points (4) are
located on the top mast bearing respectively. Suitable ring screws must be screwed
in at this point.
When lifting by crane, use the following crane points:
– Crane points for complete truck with mast assembled:
points (1) and (2) (for weight see truck data plate)
– Crane points for the basic truck:
points (4) and (5) (weight 2646 lbs / 1200 kg)
– Crane points for the mast including driver’s cab and load lifting device:
points (3) (weight 4409 lbs / 2000 kg)
2.2 Lifting the battery by crane
When lifting the battery with a crane attach suitable lifting gear to the four eyes of the
battery container (for weight see battery data plate).
NOTICE For battery removal see section “Battery removal and installation“ in
Chapter F.
2.3 Securing the truck during transport
QwW The truck must be securely fastened when being transported on a truck or a
trailer. The truck / trailer must have fastening rings.
IMPORTANT Loading shall be carried out by staff especially trained for that purpose. The
staff must be trained in securing of loads on vehicles and in handling of
securing aids for loads. In each case correct measurements shall be
determined and appropriate safety measures adopted.
H 3
0505.USA
2.1 Crane points
The crane points (1) are the eyes in the mast.
The crane points (5) are located on the side of the chassis and crane points (4) are
located on the top mast bearing respectively. Suitable ring screws must be screwed
in at this point.
When lifting by crane, use the following crane points:
– Crane points for complete truck with mast assembled:
points (1) and (2) (for weight see truck data plate)
– Crane points for the basic truck:
points (4) and (5) (weight 2646 lbs / 1200 kg)
– Crane points for the mast including driver’s cab and load lifting device:
points (3) (weight 4409 lbs / 2000 kg)
2.2 Lifting the battery by crane
When lifting the battery with a crane attach suitable lifting gear to the four eyes of the
battery container (for weight see battery data plate).
NOTICE For battery removal see section “Battery removal and installation“ in
Chapter F.
2.3 Securing the truck during transport
QwW The truck must be securely fastened when being transported on a truck or a
trailer. The truck / trailer must have fastening rings.
IMPORTANT Loading shall be carried out by staff especially trained for that purpose. The
staff must be trained in securing of loads on vehicles and in handling of
securing aids for loads. In each case correct measurements shall be
determined and appropriate safety measures adopted.
To Next Page
Loading...
Need help?
General
