Jungheinrich EKS 314 User Manual

1005.USA
E 10
2.3 o Preparing the truck for operation with an additional access code
– Attach the belt system
(see section ”Attaching the safety restraint belt” in this chapter).
– Close the safety gates securely on both sides.
– Turn the EMERGENCY DISCONNECT switch (5) to release it.
– Put the key in the key switch (3) and turn it clockwise.
– In the display unit (7) you are required to enter a 5 digit code / pin via the five func-
tion buttons (6)
NOTICE Press function key F0 (8) to assign to the five function keys (6) the digits 0 -
4 or 5 -9 for entering the code/pin.
NOTICE Unless the correct code/pin is entered, none of the truck's functions will
operate
NOTICE A maximum of 10 different code/pins can be set.
– Test the warning device (horn) (4).
– Test the operating and parking brakes.
– Carry out a test movement on the lift mast to adjust the height display.
NOTICE After a factory-set interval, you will be required to enter in the display a 5 digit
code / pin using the five function buttons (6).
QwW Press the EMERGENCY DISCONNECT switch (5) immediately if the truck
starts to move or lift when it is switched on.
NOTICE Brief steering movements caused by steering referencing are permissible.
54
8
7
3
6
1005.USA
E 10
2.3 o Preparing the truck for operation with an additional access code
– Attach the belt system
(see section ”Attaching the safety restraint belt” in this chapter).
– Close the safety gates securely on both sides.
– Turn the EMERGENCY DISCONNECT switch (5) to release it.
– Put the key in the key switch (3) and turn it clockwise.
– In the display unit (7) you are required to enter a 5 digit code / pin via the five func-
tion buttons (6)
NOTICE Press function key F0 (8) to assign to the five function keys (6) the digits 0 -
4 or 5 -9 for entering the code/pin.
NOTICE Unless the correct code/pin is entered, none of the truck's functions will
operate
NOTICE A maximum of 10 different code/pins can be set.
– Test the warning device (horn) (4).
– Test the operating and parking brakes.
– Carry out a test movement on the lift mast to adjust the height display.
NOTICE After a factory-set interval, you will be required to enter in the display a 5 digit
code / pin using the five function buttons (6).
QwW Press the EMERGENCY DISCONNECT switch (5) immediately if the truck
starts to move or lift when it is switched on.
NOTICE Brief steering movements caused by steering referencing are permissible.
54
8
7
3
6

Jungheinrich EKS 314 Specifications

General

Brand	Jungheinrich
Model	EKS 314
Category	Forklifts
Language	English