1-Port SFP Mini-Physical Interface Module Key Features
The 1-Port small form-factor pluggable Mini-Physical Interface Module (SFP Mini-PIM)
has the following key features:
•
Enables you to install and remove transceivers without powering down the device
•
Provides real-time visual status of connectivity and traffic flows
•
Provides Link Up/Down alarm
•
Supports the following transceiver types:
•
1000BASE-SX
•
100BASE-LX
•
1000BASE-LX10
•
100BASE-FX
•
1000BASE-T
•
1000BASE-LH (ZX)
•
Tri-Rate 10/100/1000BASE-T, Copper Transceiver
•
1000BASE-BX10, at 10 km (TX1310 nm / RX1490 nm)
•
1000BASE-BX10, at 10 km (TX1310 nm / RX1550 nm)
•
1000BASE-BX10, at 10 km (TX1490 nm / RX1310 nm)
•
1000BASE-BX10, at 10 km (TX1550 nm / RX1310 nm)
•
1000BASE-BX, at 40 km (TX1310 nm / 1550 nm)
•
1000BASE-BX, at 40km (TX1550 LC nm / RX1310 nm)
•
100Base-BX Fast Ethernet Optics, at 20 km (TX 1310 nm / RX 1550 nm)
•
100Base-BX Fast Ethernet Optics, at 20 km (TX 1550 nm / RX 1310 nm)
NOTE: The 1-Port SFP Mini-PIM with Ethernet connector provides 1000-Mbps
link speed. Actual bandwidth is limited to 100 Mbps.
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
Copyright © 2015, Juniper Networks, Inc.40
SRX Series Services Gateways for the Branch Physical Interface Modules Reference
To Next Page
Loading...
Need help?
General
