Features of your vehicle
1004
Wipers and washers
Operating windshield washers
1. Move the wiper speed control
switch to In OFF position.
2. Pull the lever gently toward you
to spray washer fluid on the
windshield and to run the wipers
1-3 cycles. Use this function
when the windshield is dirty. The
spray and wiper operation will
continue until you release the
lever.
If the washer does not work, check
the washer fluid level. If the fluid
level is not sufficient, you will need
to add appropriate non-abrasive
windshield washer fluid to the
washer reservoir.
The reservoir filler neck is located in
the front of the motor compart
ment on the passenger side.
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
Do not use the washer in freezing
temperatures without first warming
the windshield with the defrosters;
the washer solution could freeze on
the windshield and obscure your
vision.
䳜 To prevent possible damage to
the wipers or windshield, do not
operate the wipers when the
windshield is dry.
䳜 To prevent damage to the wiper
blades, do not use p
e
t
r
o
l
, kero
sene, paint thinner, or other sol
vents on or near them.
䳜 To prevent damage to the wiper
arms and other components, do
not attempt to move the wipers
manually.
䳜 To prevent possible damage to
the wipers and washer system,
use anti-freezing washer fluids in
the winter season or cold
weather.
Operating rear window wiper and
washer switch
The rear window wiper and washer
switch is located at the end of the
wiper and washer switch lever.