37
3
3
Safety features of your vehicle ISOFIX anchorage and top-tether anchorage
(ISOFIX anchorage system) for children
Securing a Child Restraint System
with a lap/shoulder belt
When not using the ISOFIX system,
all Child Restraint Systems must be
secured to a rear seat with the lap
part of a lap/shoulder belt.
To install a Child Restraint System
on the rear seats, do the following:
1. Place the Child Restraint System
on a rear seat and route the lap/
shoulder belt around or through
the Child Restraint System, fol
lowing the Child Restraint Sys
tem manufacturer's instructions.
Make sure the seat belt webbing
is not twisted.
2. Fasten the lap/shoulder belt latch
into the buckle. Listen for the dis
tinct "click" sound. Position the
release button so that it is easy to
access in case of an emergency.
3. Remove as much slack from the
belt as possible by pushing down
on the Child Restraint System
while feeding the shoulder belt
back into the retractor.
4. Push and pull on the Child
Restraint System to confirm that
the seat belt is holding it firmly in
place.
If your Child Restraint System man
ufacturer recommends the use of a
top-tether with the lap/shoulder
belt.
To remove the Child Restraint Sys
tem, press the release button on
the buckle and then pull the lap/
shoulder belt out of the Child
Restraint System and allow the seat
belt to retract fully.
To Next Page
Loading...
Need help?
General
