Driving your vehicle
66
Key positions
Key positions
Ignition switch position
LOCK (1)
The steering wheel locks to protect
against theft. The ignition key can
be removed only in the LOCK posi
tion.
ACC (Accessory) (2)
The steering wheel is unlocked and
electrical accessories are operative.
If difficulty is experienced turning
the ignition switch to the ACC posi
tion, turn the key while turning the
steering wheel right and left to
release the tension.
ON (3)
The warning lights can be checked
before the engine is started. This is
the normal running position after
the engine is started.
Do not leave the ignition switch ON
if the engine is not running to pre
vent battery discharge.
START (4)
Turn the ignition switch to the
START position to start the engine.
The engine will crank until you
release the key; then it returns to
the ON position. The brake warning
light can be checked in this position.
Ignition switch
䳜 Never turn the ignition switch to
LOCK or ACC while the vehicle is
moving. This would result in loss
of directional control and braking
function, which could cause an
accident.
䳜 The anti-theft steering column
lock is not a substitute for the
parking brake. Before leaving the
driver's seat, always make sure
the shift lever is engaged in 1st
gear for the manual transmission,
set the parking brake fully and
shut the engine off. Unexpected
and sudden vehicle movement
may occur if these precautions
are not taken.
To Next Page
Loading...
Need help?
General
