CHECKING TRANSMISSION FLUID
LEVEL
(1) Gauge (2) Oil Filling Plug
(3) Bleeder Plug
(A) Oil level is acceptable within this range.
1. Park the tractor on level ground,
lower the implement, and stop the
engine.
2.Check the uid level through the
uidgauge. If the level is too low,
add new oil to the prescribed level
at the oil inlet. (Refer to "Lubricants"
in the Maintenance)
Remove the bleeder plug to allow
oilowingoverbythepressure.
CHECKING AND REFUELING
(1) Fuel Tank Cap
1. Turn the key switch to "ON", check
the amount of fuel showing on the
fuel gauge.
2. Fill fuel tank when the fuel gauge
shows 1/4 or less fuel in the tank.
3. In cold climates (over -10°C) the
use of winter diesel fuel is recom-
mended.
S76Oa05a S76Oa06a
Fuel Tank Capacity
42 L (11.1 U.S.gals.)
To avoid personal injury:
Do not smoke while refueling.
Be sure to stop the engine be-
fore refueling.
•
•
CAUTION
Do not start the engine if the
amount of oil is insufcient.
•
IMPORTANT
Make sure no dust or straw de-
bris enters the fuel system.
Do not leave the fuel tank
empty. If the fuel tank is empty,
air may enter the fuel system.
Bleeding is necessary before
the next engine start.
Be careful not to spill during
refueling. If fuel is spilled, it
should be wiped off immedi-
ately, or it may cause a re.
To prevent water condensation
in the fuel tank, fill the tank
before parking the tractor after
work.
•
•
•
•
IMPORTANT
To Next Page
Loading...
Need help?
General
