3-POINT HITCH
PRECAUTIONS FOR HANDLING OF THE IMPLEMENT
1. When you remove or install the
implement, make sure that no one
stands around the tractor or between
the tractor and the implement.
2. Remove or install the implement at
a at and safe place. Please use
proper lighting at night.
3. When the heavy implement is in-
stalled, x a balance weight in front
to keep the balance.
4. In case you need to adjust the imple-
ment, apply the parking brake of
the tractor, or stop the engine, and
then perform the adjustment after
conrming that PTO switch and PTO
shift lever are in the "NEUTRAL"
position.
5. When you do draft work, you must
use the draft hitch. Do not use the
equipment without using the draft
hitch.
6. When you do draft work or you are
working on a slope, you should
increase the width of the distance
between the left and right tires, mak-
ing the tractor wider.
7. Since using different kinds of imple-
ments will make the tractor longer
than usual, be careful of people
or objects around where you are
working, especially when turning the
tractor to avoid accidents.
8. Do not use a person or object(s)
instead of the balance weight.
9. When you are working with the front
loader, keep the tractor balanced
by attaching the implement in the
rear.
Carefully read the user’s manual
for the implement to be used to
ensure safe and correct usage.
If this is not observed, it may
cause personal injury.
If the toxic chemical sprayer
(agricultural chemicals, etc)
is used, make sure to wear a
protective mask and observe
the safety cautions shown on
the bottle.
•
•
WARNING
Remove the drawbar if the imple-
ment is installed.
•
NOTE
To Next Page
Loading...
Need help?
General
