.
OPERATION
OPERATION
PARKING MACHINE
WARNING
Avoid stopping suddenly. Leave an adequate margin when stopping.
Avoid parking the machine on a slope.
If the machine has to be parked on a slope, set it at right angles to the
slope, put blocks under the tires and dig the blade into the ground
surface to prevent the machine from moving.
If the control levers are touched by mistake, the work equipment or
machine may suddenly move and cause a serious accident. Before
leaving the operator's seat, always set the gearshift lever to the P
position.
WHEN SELECTING MANUAL MODE
1.
Release accelerator pedal (1).
2. Depress brake pedal (2). Before the machine comes to a stop,
depress inching pedal (3).
REMARK
As this model has the linked control function of torque converter
with direct drive, the engine does not stop even if depressing the
inching pedal belatedly or not depressing it at all.
However, as the lockup is automatically released to prevent the
engine from stopping, the machine becomes in torque converter
state.
After the machine starts and the engine and travel speeds
increase, the machine automatically returns to lockup state.
3 - 164
To Next Page
Loading...
Need help?
General
