.
MAINTENANCE
SERVICE PROCEDURE
EVERY 250 HOURS SERVICE
Maintenance for every 50 hours service should be carried out at the same time.
LUBRICATING
WARNING
Set the gear shift lever to the P (Parking) position and fix the front and rear frames by using the articulate lock pin.
Lower the work equipment to the ground and stop the engine.
Grease on flat ground.
1.
Using a grease pump, pump in grease through the grease fittings shown by arrows.
2. After greasing, wipe off any old grease that was pushed out.
Articulate pin (2 places)
Articulate cylinder pin (4 places)
Blade lift cylinder yoke (6 places)
4 - 45
To Next Page
Loading...
Need help?
General
