.
SAFETY
GENERAL PRECAUTIONS COMMON TO OPERATION AND MAINTENANCE
PRECAUTIONS WHEN STANDING UP FROM OPERATOR'S SEAT
Before standing up from the operator's seat, such as when
adjusting the position of the seat, always lower the work equipment
completely to the ground, set gearshift lever (1) to the P (Parking)
position, then stop the engine.
If the control levers are touched by mistake, the machine may
suddenly move and cause serious personal injury or death.
PRECAUTIONS WHEN LEAVING MACHINE
If the proper procedures are not taken when parking the machine,
the machine may suddenly move off by itself, and this may lead to
serious personal injury or death. Always do the following.
When leaving the machine, always lower the work equipment
completely to the ground, set gearshift lever (1) to the P
(Parking) position, then stop the engine.
Use the key to lock all the equipment. Always remove the key,
take it with you, and keep it in the specified place.
To ensure that there is enough space to get on or off the
machine, raise the steering column fully when getting off the
machine.
EMERGENCY EXIT FROM OPERATOR'S CAB
Machines equipped with a cab have doors on the left and right sides. If the door on the one side does not open,
escape from the door on the other side.
2 - 18
To Next Page
Loading...
Need help?
General
