.
MAINTENANCE
SERVICE PROCEDURE
EVERY 50 HOURS SERVICE
LUBRICATING
WARNING
Set the gear shift lever to the P (Parking) position and fix the front and rear frames by using the articulate lock pin.
Lower the work equipment to the ground and stop the engine.
Grease on flat ground.
Apply grease to the grease fittings shown by arrows.
Sliding surface at top of circle, sliding surface on inside of circle,
face of circle gear teeth
Using a grease pump, pump in grease through the grease fittings shown by arrows.
After greasing, wipe off any old grease that was pushed out.
Front axle center pin (2 places)
4 - 42
To Next Page
Loading...
Need help?
General
