Specifying Settings From the Control Panel
3
bizhub 750/600 3-13
Specifying Settings From the Control Panel Chapter 3
3 Touch [New].
The Register FTP screen appears.
4 Touch [Name] and type in the name using the keyboard that appears
on the screen.
5 Touch [OK].
6 Touch [Host Address].
– Enter the host address or IP address.
– To enter the host address, check that [Host Name Input] is select-
ed, and then type in the host address using the keyboard that ap-
pears on the screen.
– To enter the IP address, touch [IP Address Input], and then enter
the value. If the value was incorrectly entered, press the [C] (clear)
key to erase the value, and then use the keypad to type in the cor-
rect value. To change an entered value, touch [←] and [→] to move
the cursor to the desired position, and then type in the desired val-
ue.
– If [IP Address Input] is touched after entering the host address, the
host address is cleared.
– If the IP address is entered first, then [Host Name Input] is touched,
the IP address that was entered is displayed in the text box.
To Next Page
Loading...
Need help?
General
