Introduction
This instrument is a Chroma Meter/Luminance Meter that can measure luminance/
chromaticity with accuracy comparable to spectroradiometers, through the adoption of a
newly developed lter. Read this manual carefully before use.
Packing materials of the product
Be sure to keep all packing materials used for shipping the product (cardboard box,
cushioning material, plastic bags, etc.).
This instrument is a precision measuring instrument. When transporting the instrument
to a service facility for maintenance or for other reasons, be sure to use these packing
materials to minimize shock or vibration.
If the packing materials are lost or damaged, contact a KONICA MINOLTA-authorized
service facility.
Notes on Use
Operating Environment
• The AC adapter (AC-A305J/L/M) provided as an optional accessory of the instrument is
designed for indoor use only. Do not use it outdoors.
• This instrument consists of precision electronic components and must not be
disassembled.
• For the AC adapter, use the one provided as an optional accessory (AC-A305J/L/M)
and connect it to an AC outlet of the rated voltage and frequency (100-240 VAC
50/60 Hz). Use an AC power supply of the rated supply voltage (within ±10%).
• This instrument is classied as a pollution level 2 product (equipment mainly used in
manufacturing sites, laboratories, warehouses, or other equivalent locations). Use it in
an environment with no metallic dust and no possibility of condensation.
• This instrument belongs to installation category II (equipment which is powered through
the connection to commercially available power supply).
• Be careful not to allow foreign matter to enter the instrument. It poses an extreme
danger to use the instrument with water or metal objects inside.
• Do not use the instrument in direct sunlight or near a heating appliance. The internal
temperature of the instrument may become much higher than the ambient temperature,
leading to breakdown.
• Do not use the instrument in areas with rapid temperature change to avoid
condensation.
• Avoid the use of the instrument in areas with extreme dust or humidity.
• The instrument should be installed and used at a temperature between 0°C and 40°C
and a relative humidity of 85% or less (at 35°C) with no condensation. Any use outside
of this range may not satisfy the expected performance.
• Do not use the instrument at altitudes higher than 2,000 m.
3
To Next Page
Loading...
Need help?
General
