Konica Minolta CHROMA METER User Manual

Remote Mode
To control the instrument from a PC, use the data management software CS-S20. For the
specications and operation of CS-S20, refer to the instruction manual of CS-S20.
When the instrument is connected to a PC and CS-S20 is active on the PC, the instrument
enters remote mode automatically.
While the instrument is controlled with a PC, "REMOTE" is displayed at the bottom of the
LCD screen. (Refer to page 16.)
While this message is displayed, the key operation on the instrument is disabled except for
the following case:
• There is a measurement mode that performs measurement when the Measuring button
on the instrument is pressed and then sends the measured value to the PC.
If you want to control the instrument with a PC using your own program, you can download
the communication specications and other information from KONICA MINOLTA web site
at:
http://www.konicaminolta.com/instruments/download/software/
(The URL above is subject to change without prior notice.)
(If you cannot nd relevant pages, search the site with keywords "CS" and "download".)
95
Communication
REMOTE

Konica Minolta CHROMA METER Specifications

General

Brand	Konica Minolta
Model	CHROMA METER
Category	Measuring Instruments
Language	English