Chapter 5 Disassembly and Assembly
5-56
5 Replace the parts.
6 Install the receiver.
•
4 screws (M4 x 6)
Press the receiver in the direction of the arrow shown
in the figure to secure it to the guide on the slide pack.
7 Connect the connector (JP17), that was removed
in Step 2, to the original position to secure the
cable to the guide with the
wiring band.
8 See the descriptions following Step 7 in "5.4.12 Replacing the Receiver Belt (Page 5-59)" to
install the receiver belt.
Now, you have finished with the procedures to replace the receiver (receiver unit assembly).
A
Im
ortant
If the cable has been unplugged, align the
white mark of the cable with the Hole A
shown in the figure, then bind the cable with
the wiring band to fix.
First Front Side
JP17
B
Im
ortant
Make sure that no twisted part is found in
the cable, then align the white mark of it with
the fixing position (B in the figure) to fix it.
To Next Page
Loading...
Need help?
General
