Konica Minolta REGIUS 110 Service Manual

Chapter 3 Troubleshooting
3-21
3.2.10 06450 ~ 06483: Detach Detection Sensor Errors
• Error codes S column: Errors at the read operation/calibration.
• Error codes E column: Errors during erase operation.
• Error codes I column: Errors during initialization.
References for response method
•
See "2.5.6 Detach Detection Unit (Page 2-16)" for the position of the detach detection sensors.
• See "2.5.8 Framework (Page 2-19)" for the position of the MDU.
• See "5.8.1 Replacing the Detach Detection Sensor (Upper) (Page 5-86)" or "5.8.2 Replacing the
Detach Detection Sensor (Lower) (Page 5-87)"for the procedure to replace the detach detection
sensors.
• See "5.8.3 Replacing the Detach Detection Roller (Page 5-89)" for the procedure to replace the
detach detection roller.
• See "5.6.2 Replacing the LMC (Page 5-79)" for the procedure to replace the LMC.
Error code Description of the error Response
(References to replacement methods are
listed at the end of the table.)
S E I
06450 06465 06480 Plate detach detection (when
reading or erasing)
Detach detection sensor went
ON during the read action or the
erase action.
• Stop using the cassette with an error,
and request a repair at the factory.
• If same error occurs with multiple
cassettes, adjust the position of the
detach detection roller and the detach
detection sensor.
06451 06466 06481 Detach detection sensor error
(when not operating)
Detach detection sensor went
ON when the read action or the
erase action is not performing.
Confirm following and replace the faulty parts.
• Detach detection sensor
• Sensor wire (top):
JP54 ~ ACN6 (LMC)
• Sensor wire (bottom):
JP55 ~ ACN6 (LMC)
• LMC
06452 Detach detection sensor error
(during startup)
Detach detection sensor was
ON during the initialization by
PowerON.
1. Confirm for foreign object inside the
equipment, and remove it if there is
any.
2. Confirm following and replace the
faulty parts.
• Detach detection sensor
• Sensor wire (top):
JP54 ~ ACN6 (LMC)
• Sensor wire (bottom):
JP55 ~ ACN6 (LMC)
• LMC
06453 06468 06483 Detach detection sensor error
(during initialization)
Detach detection sensor was
ON during the initialization after
closing the second front door.

Konica Minolta REGIUS 110 Specifications

General

Brand	Konica Minolta
Model	REGIUS 110
Category	Measuring Instruments
Language	English