Konica Minolta REGIUS 110 Service Manual

Chapter 3 Troubleshooting
3-20
3.2.9 06400 ~ 06432: Back Plate Detection Sensor Errors
• Error codes S column: Errors at the read operation/calibration.
• Error codes E column: Errors during erase operation.
• Error codes I column: Errors during initialization.
References for response method
•
See "2.5.8 Framework (Page 2-19)" for the position of the back plate absorption detection sensor
and the MDU.
• See "5.10.7 Replacing the Back Plate Absorption Detection Sensor (Page 5-126)" for the procedure
to replace the back plate absorption detection sensor.
• See "5.10.2 Replacing the MDU (Page 5-116)" for the procedure to replace the MDU.
Error code Description of the error Response
(References to replacement methods are
listed at the end of the table.)
S E I
06400 06415 06430 Back plate detection sensor
error (before moving to read
position)
Back plate absorption detection
sensor was ON before moving
the push plate to the read
position after separating the
cassette.
Confirm following and replace the faulty parts.
• Back plate absorption detection
sensor
• Sensor wire: JP48 ~ MCN4 (MDU)
• MDU
06401 06416 06431 Back plate detection sensor
error (when stopped at read
position)
Back plate absorption detection
sensor was OFF when the push
plate is at the read position after
separating the cassette.
06402 06417 06432 Back plate detection sensor
error (after moving to press
down position)
Back plate absorption detection
sensor was ON after moving the
push plate to the press down
position after separating the
cassette.

Konica Minolta REGIUS 110 Specifications

General

Brand	Konica Minolta
Model	REGIUS 110
Category	Measuring Instruments
Language	English