KTM 125 ECX EU - Positioning the Fork Protection; Removing the Fork Legs; Installing the Fork Legs

SERVICE WORK ON THE CHASSIS 46
10.6Positioning the fork protection
B00800-11
– Position the fork protection on the left fork leg. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Position the brake line. Position the clamp and mount and tighten screws .
– Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
10.7Removing the fork legs x
(All EXC models)
– Remove the headlight mask with the headlight. ( p. 85)
(XC-W)
– Remove the start number plate. ( p. 53)
–
Remove the front wheel. x ( p. 78)
B00798-10
– Remove screws  and take off the clamp.
– Remove cable binder .
– Remove screws  and take off the brake caliper.
– Hang the brake caliper and the brake line loosely to the side.
B00799-10
(EXC EU/AUS, XC‑W)
– Loosen screws . Remove the fork leg on the left.
– Loosen screws . Remove the fork leg on the right.
B00804-10
(EXC SIX DAYS)
– Loosen screws . Remove the fork leg on the left.
– Loosen screws . Remove the fork leg on the right.
10.8Installing the fork legs x
303637-10
(All EXC models)
– Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
Position bleeder screws  toward the front.