SERVICE WORK ON THE ENGINE 18
131
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use effective exhaust extraction when starting or
running the engine in an enclosed space.
– Start the engine and check the response.
18.2 Checking the engine oil level
Condition
The engine is at operating temperature.
Preparatory work
– Stand the motorcycle upright on a horizontal surface.
W00360-10
Main work
– Check the engine oil level.
Info
After switching off the engine, wait one minute before
checking the level.
The engine oil is at a level between lower edge
A
and the
middle of level viewer
B
.
»
If the engine oil is not up to lower edge
A
of the level
viewer:
– Add engine oil. ( p. 134)
18.3 Changing the engine oil and oil filter, cleaning the oil screens
Warning
Danger of scalding Engine and gear oil get hot when the motorcycle is operated.
– Wear suitable protective clothing and safety gloves.
– In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Drain the engine oil with the engine at operating temperature.
Preparatory work
(500 EXC‑F SIX DAYS US)
– Remove the engine guard. ( p. 91)
– Park the motorcycle on a level surface.
To Next Page
Loading...
Need help?
General
