KTM 500 EXC F 2024 User Manual

11 TUNING THE CHASSIS
58
W00322-10
(500 EXC‑F SIX DAYS US)
The holes on the handlebar support are placed at a distance
of
A
from the center.
Hole distance
A
3.5 mm (0.138 in)
The handlebar support can be mounted in two different posi-
tions.
11.15 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
– Change the handlebar if the handlebar is damaged or bent.
W00324-10
(500 EXC‑F US)
–
Remove screws
1
. Take off the handlebar clamp. Take
off the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables or lines.
–
Remove screws
2
. Take off the handlebar support.
– Place the handlebar support in the required position.
Mount and tighten screws
2
.
Guideline
Screw, handle-
bar holder
M10 40 Nm (29.5 lbf ft)
Loctite
®
243™
Info
Position the handlebar support so that it is even.
– Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.

KTM 500 EXC F 2024 Specifications

General

Displacement	510.9 cm³
Bore x Stroke	95 mm x 72 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Front Suspension	WP XPLOR-USD, Ø 48 mm
Rear Suspension	WP XACT Monoshock with linkage
Ground Clearance	355 mm
Seat Height	960 mm
Dry Weight	106.5 kg
ABS	No
Engine Type	Single Cylinder, 4-Stroke Engine
Fuel System	Electronic fuel injection (EFI)
Front Brake	Disc brake 260 mm
Rear Brake	Disc brake 220 mm
Fuel Tank Capacity	8.5 liters
Frame	Central double-cradle type 25CrMo4 steel