8 PREPARING FOR USE
40
8.3 Starting power of lithium-ion batteries at low temperatures
402555-01
Lithium-ion batteries are far lighter than lead batteries, have a low
self-discharge rate, and have more starting power at temperatures
over 6 °C (43 °F).
Several attempts to start may be required. Press the start button
for 5 seconds, and wait 15 seconds between attempts. At low tem-
peratures, wait for 30 seconds. The pauses are necessary so that
the heat created can distribute through the lithium-ion battery and
the lithium-ion battery is not damaged.
The starting power increases as the battery warms up.
Always make sure the lithium-ion battery is charged to that there
is enough power to spare for starting at low temperatures.
After 6 unsuccessful starting attempts, do not try again, and check
the vehicle for other errors instead.
8.4 Preparing the vehicle for difficult operating conditions
Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can result in
significantly increased wear of components, such as the drive train, brake system, or suspension compo-
nents. For this reason, it may be necessary to inspect or replace parts before the next scheduled service.
– Clean the air filter and air filter box. ( p. 75)
Info
Check the air filter approx. every 30 minutes.
– Check the connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
– Clean and dry the connector, or change it if necessary.
Difficult operating conditions are:
– Rides on dry sand. ( p. 40)
– Rides on wet sand. ( p. 41)
– Rides on wet and muddy circuits. ( p. 42)
– Rides at high temperatures or slow riding. ( p. 42)
– Riding at low temperatures and in snow. ( p. 42)
8.5 Preparing the vehicle for rides on dry sand
102136-01
– Mount the air filter dust cover.
Air filter dust cover (79006920000)
Info
Observe the fitting instructions for KTM PowerParts.
To Next Page
Loading...
Need help?
General
