MAINTENANCE WORK ON CHASSIS AND ENGINE 101
9.47Mounting the seat
100276-10
– Hook slot of the seat onto screw , press the rear downward and at the same time
push it forward.
– Push locking pin into lock housing and push the back of the seat down until the
locking pin locks in place with an audible click.
– Finally, check that the seat is correctly mounted.
9.48Removing the battery x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least 15
minutes and contact a physician.
– Switch off all power consumers and switch off the engine.
– Remove the seat. ( p. 100)
To Next Page
Loading...
Need help?
General
