MAINTENANCE WORK ON CHASSIS AND ENGINE 115
600612-10
– Pull bulb socket out of the reflector.
– Pull parking light bulb out of the bulb socket.
– Fit a new parking light bulb in the bulb socket.
Parking light (W2,1x9,5d) ( p. 159)
– Insert the bulb socket in the reflector.
– Insert the rubber cap.
– Refit the headlight mask with the headlight. ( p. 112)
9.58Changing the flasher bulb
Note
Damage to reflector Keep the glass of the bulb free of grease.
– Clean the glass bulb with a clean cloth before mounting. Any grease on the glass will evaporate by the heat and be deposited on the
reflector.
100301-10
– Remove the screw from the rear of the flasher housing.
– Tilt the headlamp diffuser carefully forward and take it off.
– Lightly squeeze the orange plug in the area of the holding lugs and take it off.
– Press the flasher bulb carefully into the socket, turn it about 30° anticlockwise, and
take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
– Press the new flasher bulb carefully into the socket and turn it clockwise until it stops.
Flasher light (BA15s) ( p. 159)
To Next Page
Loading...
Need help?
General
