MAINTENANCE WORK ON CHASSIS AND ENGINE 74
9.24Adjusting chain guide x
100299-10
– Remove screws and . Take off the chain guide.
Condition
Number of teeth: ≤ 44 teeth
– Insert nut in hole . Position the chain guide.
– Mount and tighten screws and .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Condition
Number of teeth: ≥ 45 teeth
– Insert nut in hole . Position the chain guide.
– Mount and tighten screws and .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
9.25Checking brake discs
Warning
Danger of accidents Reduced braking due to worn brake discs.
– Worn brake discs should be replaced immediately in an authorized KTM workshop.
To Next Page
Loading...
Need help?
General
