83PERIODIC SERVICE
BReplacing Engine Oil Filter
To avoid personal injury or death:
A Be sure to stop the engine before replacing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
BChanging Transmission Fluid / Replacing
Hydraulic Oil Filter
C Cleaning Magnetic Filter
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the drain plugs at the bottom of the
transmission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil filter.
4. Wipe off metal filings from the magnetic filter with a
clean rag.
5. Put a film of clean transmission oil on the rubber seal
of the new filter.
(1) Drain plug
(1) Engine oil filter
(1) Drain plugs
(1) Hydraulic oil filter
(2) Magnetic filter (Wipe off metal filings)
0000012651.book Page 83 Thursday, October 1, 2015 3:53 PM
To Next Page
Loading...
Need help?
General
