Kubota MX5200 User Manual

PERIODIC SERVICE74
EVERY 50 HOURS
BLubricating Grease Fittings
Apply a small amount of multipurpose grease to the
following points every 50 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
When apply grease to forward front axle support, remove
the breather plug and apply grease until grease overflows
from breather plug port.
After greasing reinstall the breather plug.
(1) Grease fitting (Knuckle shaft)[RH, LH]
(1) Grease fitting (Front axle support)
(2) Breather plug
(1) Grease fitting (Front axle support)
(1) Grease fitting (Front axle gear case support) [RH, LH]
(1) Grease fitting (Top link)
(2) Grease fitting (Lifting rod) [RH]
(3) Grease fitting (Top link bracket)(with draft control)(if equipped)
0000012651.book Page 74 Thursday, October 1, 2015 3:53 PM

Kubota MX5200 Specifications

General

Engine Type	Diesel
Lift Capacity	2, 535 lbs
Fuel Type	Diesel
Number of Cylinders	4
Brakes	Wet disc
Hydraulic System Type	Open center
Hydraulic Pump Capacity	8.7 gpm
PTO Speed	540 RPM
3-Point Hitch	Category I
Transmission Type	Gear, HST
Number of Gears	8 forward, 8 reverse
Tire Size (Front)	7-16