97TROUBLESHOOTING
POWER TRAIN TROUBLE SHOOTING
If something is wrong with the power train, the master
system warning indicator starts blinking and the error
code shown below is displayed on the liquid crystal
display, indicating the location of the trouble. If an error
code appears, immediately contact your local KUBOTA
Dealer for repairs.
(1) Master system warning indicator
(2) Error code
Displayed error code Trouble Operator’s action
E-20 Communication trouble
Contact your local KUBOTA Dealer.
E-31
Meter's part code and ECU model setting not
compatible
E-40 Input voltage of lever sensor from ECU is in trouble.
E-75 Acceleration sensor output out of spec
E-84 Acceleration sensor maladjusted
E-93 Relay for engine starter motor is in trouble.
Contact your local KUBOTA Dealer.
The engine cannot start.
E-94 Relay for engine shut off is in trouble.
Contact your local KUBOTA Dealer.
The Operator Presence Control (OPC)
system gets activated, and the engine stops
itself.
E-95 Solenoid (PTO) is in trouble.
Contact your local KUBOTA Dealer.
The PTO shaft cannot rotate.
0000012651.book Page 97 Thursday, October 1, 2015 3:53 PM
To Next Page
Loading...
Need help?
General
