OPERATING THE ENGINE24
IMPORTANT:
[Manual Transmission Type]
A Because of the safety devices, the engine will not start
except when the PTO clutch control switch is placed in
the "OFF" position and shuttle shift lever is placed in
the "NEUTRAL" position.
[HST Type]
A Because of the safety devices, the engine will not start
except when the PTO clutch control switch is placed in
the "OFF" position, the speed control pedal is placed
in the "NEUTRAL" position.
If the lamp is still on, immediately stop the engine and
determine the cause.
[Manual Transmission Type]
COLD WEATHER STARTING
If the ambient temperature is below -5 (23 ) and the
engine is very cold, follow the procedure below after
taking the step 1 through 8 in the previous pages.
(If the engine fails to start after 10 seconds, turn off the
key for 30 seconds. Then repeat steps (9) and (10). To
protect the battery and the starter, make sure that the
starter is not continuously turned for more than 10
seconds.)
BBlock Heater (if equipped)
A block heater is available as an option from your dealer.
It will assist you in starting your tractor when the ambient
temperature is below -20 (-4 ).
9. Turn the key to "START" position and
release when the engine starts.
10. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
11. Release the clutch pedal.
9. Turn the key to "ON" (glow plug) and
keep it there until glow plug indicator
goes off.
(1) Glow plug indicator
10. Turn the key to the start position and
the engine should start.
0000012651.book Page 24 Thursday, October 1, 2015 3:53 PM
To Next Page
Loading...
Need help?
General
