ENGINE
L3560, L4060, L4760, L5060, L5460, L6060, WSM
1-S10
3. TIGHTENING TORQUES
Tightening torques of screws, bolts and nuts on the table below are especially specified.
(For general use screws, bolts and nuts: Refer to "5. TIGHTENING TORQUES" on page G-11.)
Tractor
Item N·m kgf·m lbf·ft
Filter comp (DPF) mounting clamp band 16 to 20 1.7 to 2.0 12 to 14
Temperature sensor 25 to 34 2.5 to 3.5 18 to 25
Differential pressure pipe 16 to 22 1.6 to 2.3 12 to 16
Joint bolt for PTO delivery pipe 35 to 39 3.5 to 4.0 26 to 28
Engine and clutch housing mounting screw 78 to 90 7.9 to 9.2 58 to 66
Engine and clutch housing mounting nut 103 to 117 10.5 to 12.0 76.0 to 86.7
Joint bolt for power steering delivery pipe 40 to 49 4.0 to 5.0 29 to 36
Retaining nut of power steering delivery pipe 49 to 58 5.0 to 6.0 37 to 43
Joint bolt for HST return pipe (HST type) 88 to 98 9.0 to 9.9 65 to 72
Front axle frame mounting screw (7T) 78 to 90 7.9 to 9.2 58 to 66
Front axle frame mounting screw (9T) 103 to 117 10.5 to 12.0 76.0 to 86.7
Muffler pipe mounting screw 31 to 37 3.2 to 3.7 23 to 27
Exhaust flange mounting screw 31 to 37 3.2 to 3.7 23 to 27
Front loader pipe retaining nut 90 to 108 9.18 to 11.0 66.4 to 79.6
Clutch mounting screw 24 to 27 2.4 to 2.8 18 to 20
Outer roof mounting screw (CABIN type only) 3.5 to 4.0 0.36 to 0.40 2.6 to 2.9
Cabin mounting bolt and nut (CABIN type only) 12.4 to 14.7 12.6 to 15.0 91.2 to 108
To Next Page
Loading...
Need help?
General