ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-S20
(3) Mode "B" (Traveling Speed Coefficient Input Mode) Input the 4 Digit Tire
Code for Correct Travel Speed to the Electronic Instrument Panel Memory
Panel
• When the tire size is changed or electronic instrument
panel is replaced, this operation is required.
1. While holding down the display mode switch, turn on the main
switch.
2. Mode selection display (a) is indicated on the LCD.
3. Press the display mode switch. The buzzer rings and the
marked display moves.
4. Select the Mode '"B".
5. Hold down the display mode switch for more than 2 seconds.
6. "Speed Coefficient 0000 or 4-digit" numerical number is
displayed (b).
7. To change the 4-digit numerical number, select the operation
coefficient according to the tractor model and tire size.
(Numerical Modification)
• Set the desired speed coefficient as follow :
• Each time the display mode switch is pressed, the marked
display shifts to the next digit. Shift the marked display to the
desired position.
8. Hold down the display mode switch more than 2 seconds
9. Press the display mode switch and the number increases one
by one.
10. When the select number comes, hold down the display mode
switch more than 2 seconds.
11. Repeat the above steps to input the operation coefficient.
12. When the 4-digit operation coefficient has been input, press the
display mode switch to shift the marked arrow key to the "SET"
(c) position.
13. Hold down the display mode switch for more than 2 seconds to
preserve the operation coefficient in the panel's memory.
14. "OK" is displayed (d): The operation coefficient has been input
correctly.
15. If "NG" is displayed: Incorrect input. Repeat the procedure.
16. Turn off the main switch.
9Y1210824ELS0013US0
Tractor Model Rear Wheel tire size Operation Coefficient
L3560 12.4-24 (R1) 2358
L4060
14.9-24 (R1)
2097
L4760 2662
L5060
L5460
L6060
14.9-28 (R1) 2108
(a) Mode Selection Display
(b) Input Display
(c) Correct Preserving Display
(d) Confirmation Display