Kubota WSM L6060 User Manual

TRANSMISSION
L3560, L4060, L4760, L5060, L5460, L6060, WSM
3-S123
7. SERVICING
[1] MANUAL TRANSMISSION
(1) Bearing, Gear and Shaft
Checking Bearing
1. Hold the inner race, and push and pull the outer race in all
directions to check for wear and roughness.
2. Apply transmission fluid to the bearing, and hold the inner race.
Then turn the outer race to check rotation.
3. If there is any problem, replace it.
9Y1210824TRS0127US0
Clearance between Gear and Spline
1. Secure the gear with a vise.
2. Set a dial indicator (lever type) with its finger on the spline.
3. Move the shaft to measure the clearance.
4. If the clearance exceeds the allowable limit, replace them.
9Y1210824TRS0128US0
Clearance between Shift Fork and Shift Gear Groove
1. Place for in the groove to check clearance with feeler gauge.
2. If the clearance exceeds allowable limit, replace.
9Y1210824TRS0129US0
Clearance between Gear and Shaft
1. Measure the shaft O.D. (rubbing surface).
2. Measure the gear I.D. (rubbing surface).
3. Measure the O.D. of the two needles installed diagonally in the
needle bearing.
4. Calculate the clearance
(Clearance = Gear I.D. – {(2 × needle O.D.) + shaft O.D.})
5. If the clearance exceeds the allowable limit, replace them.
9Y1210824TRS0130US0
Clearance between gear
and spline
Factory specification
0.030 to 0.078 mm
0.0012 to 0.0030 in.
Allowable limit
0.2 mm
0.008 in.
Clearance between shift
fork and shift gear
groove
Factory specification
0.20 to 0.40 mm
0.0079 to 0.015 in.
Allowable limit
0.8 mm
0.03 in.
Clearance between gear
and shaft
Factory specification
0.021 to 0.054 mm
0.00083 to 0.0021 in.
Allowable limit
0.1 mm
0.004 in.
KiSC issued 03, 2016 A

Kubota WSM L6060 Specifications

General

Brand	Kubota
Model	WSM L6060
Category	Tractor
Language	English