2MN/2N1-1
1-3-89
U234 Setting punch destination
Description
Sets the destination of punch unit of 1000-sheet finisher or 4000-sheet finisher.
Purpose
To be set when installing a different punch unit from the destination of the machine.
Setting
1. Press the OK key.
2. Select the destination.
Initial setting: Inch (Inch specifications)/Europe Metric (Metric specifications)
3. Press the OK key. The setting is set.
4. Exit the maintenance mode, perform shut-down, and turn the main power switch to off and on
again. Allow more than 5 seconds between Off and On.
Item No. Description
Display Description
Auto Conforms to destination settings.
Japan Metric Metric (Japan) specifications
Inch Inch (North America) specifications
Europe Metric Metric (Europe) specifications
To Next Page
Loading...
Need help?
General