Kyocera FS-9120DN User Manual

Chapter 3 Using the Operator Panel
3-52
Press the  or  key repeatedly until Others > ap-
pears.
Press the  key.
Press the  or  key repeatedly until > Buzzer ap-
pears.
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the  or  key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Auto Continue Setting
When Auto Continue is enabled, the printer will automatical-
ly print the next received data following a preset amount of
time passes after any one of the following errors occurs:
Memory overflow Press GO
Print overrun Press GO
KPDL error Press GO
File not found Press GO
RAM disk error Press GO
MemoryCard err Press GO
Hard disk err Press GO
Duplex disabled Press GO
Add Staple Press GO
Chad box full Press GO
If one of the above errors is caused by someone on a network
where the printer is being shared, for example, data sent from
another person will be printed after a preset amount of time.
For setting the auto continue recovery time, see the next sec-
tion.
Press the MENU key.
Press the  or  key repeatedly until Others > ap-
pears.
Press the  key.
Press the  or  key repeatedly until Auto
Continue > appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the  or  key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery
time for Auto Continue.
Press the MENU key.
Press the  or  key repeatedly until Others > ap-
pears.
Press the  key.
Press the  or  key repeatedly until Auto
Continue Mode > appears.
Press the  key and display >>Auto Continue
Timer.
Others >
>Buzzer
On
>Buzzer
? On
2
3
4
5
6
7
8
1
Others >
>Auto Continue >
Mode Off
>Auto Continue
Mode ? Off
Others >
>Auto Continue >
Mode On
2
3
4
5
6
7
8
1
2
3
4
5

Kyocera FS-9120DN Specifications

General

I/O ports	1 x Fast Ethernet 10/100 Base TX; 1 x High speed bi-directional parallel (IEEE 1284); 1 x USB 2.0 (High-Speed); 1 x KUIO LV Option-Interface slot.
Custom media sizes	88 x 148 mm - 297 x 450 mm
Power requirements	AC 220/240 V 50/60 Hz
Standard input trays	2 x 500
Recommended media weight	60 - 105 g/m²
Power consumption (active)	920 W
Maximum print size	297 x 420 mm
Maximum ISO A-series paper size	A3
Color	No
Print technology	Laser
Time to first page (black, normal)	7 s
Print speed (black, normal quality, A4/US Letter)	36 ppm
Memory slots	2
Storage media	HDD
Processor model	Power PC 750CX
Built-in processor	Yes
Maximum internal memory	544 MB
Internal storage capacity	20 GB
Sound power level (standby)	39 dB
Sound pressure level (printing)	53 dB
Total input capacity	1200 sheets
Maximum input capacity	4200 sheets
Paper tray 2 input capacity	200 sheets
Maximum duty cycle	55000 pages per month
Sustainability certificates	ENERGY STAR
Power consumption (standby)	160 W
Power consumption (PowerSave)	12 W

Weight and Dimensions

Dimensions (WxDxH)	585 x 639 x 615 mm