Kyocera KM-3050 User Manual

Setup and Registration
6-16 OPERATION GUIDE
Transmission Restriction
This function allows you to send or receive originals only when
communication requirements are met. Using this function can limit other
parties with which you can communicate.
Specifically, you must register communication requirements (Permit FAX
No./Permit ID No.) and set the transmission limit in advance. When the
machine sends or receives originals, you do not need to perform a special
operation for this particular function, and you can operate the machine
normally. When sending or receiving has actually started, the machine
correctly conducts transmission that meets communication requirements,
but when the transmission does not meet the requirements, the machine
indicates an error. This mode also allows you to set a [Reject List] for
Reception Restriction so that reception from senders on the list of Rejected
FAX numbers or from senders whose Local FAX Number is not registered
are rejected.
NOTE: Before using transmission restriction, be sure to read the
following prerequisites, communication establishing requirements, and
reception rejection requirements thoroughly, and consult with the other
parties with which you communicate.
Prerequisites
Communication Establishing
Requirements
Send
Restrictions
• Register Permitted FAX
numbers or Permitted ID
numbers.
†
(Refer to
Registering Permit FAX No. on
page 6-17 or Registering
Permit ID No. on page 6-21.)
• Send restriction settings are
specified in [Permit List +
Address Book] in Send
Restrictions. (Refer to Setting
Send Restriction on page 6-
23.)
• Register the Local FAX
Numbers or Local FAX IDs of
other parties.
• The recipient’s Local FAX
Number matches a Permitted
FAX No. registered on the
machine.
• The recipient’s Local FAX ID
matches a Permitted ID
registered on the machine.
• When the number was dialed
using the Address Book or
One-touch keys, the last 20
digits of the dialed number
match the last 20 digits of the
recipient’s Local FAX Number.
(Excludes manual
transmissions.)

Kyocera KM-3050 Specifications

Power

voltage	120V
frequency	60Hz
current	11.5A

System Memory

standard RAM	512MB
maximum RAM	1GB
hard drive capacity	80GB

Output Speeds

warm-up time	Within 30 Seconds
first copy out time	3.9 Seconds
pages per minute (letter)	30

Weight and Dimensions

width	23.6"
depth	25.4"
height	29.3"
weight	188 lbs