Kyocera KM-3050 User Manual

FAX Operation (Advanced)
4-14 OPERATION GUIDE
Remote Switch Function
You can start fax reception by operation from the connected telephone set.
This function is convenient for using this machine and a telephone set
(commercially available product) in combination installed at places distant
from each other.
To start fax reception by operation from the connected telephone set, use
the following operation.
NOTE: In order to use remote switch, it is necessary to connect the tone
signal-sending telephone set (commercially available product) to the
machine. However, even if it is a tone signal-sending telephone set, this
function may not be used satisfactorily depending on the type of
telephone set. For details, contact our agent or the store where you
purchased this machine.
How to Register Remote Switch Dial
Remote switch dial is set to 55 at the factory, but you can change the dial
number.
1
Press the System Menu key.
2
Press [FAX/i-FAX], [Next] of Reception, [Next] of FAX, and then [Change]
of Remote SW Dial.
3
Press [+]/[-] or the
numeric keys to
enter the number
you newly register.
(00 to 99)
4
Press [OK].
5
To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Using the Remote Switch Dial
To start fax reception by operation from the connected telephone set, use
the following operation.
Status
FAX - Remote SW Dial
Set a number which a connect ed telephone c an use
to remotely initiate a switch to FAX mode.
Use [-]/[+] or the numeric keys to enter a number.
Cancel OK
55
10/10/2007 10:00
(00 -99)

Kyocera KM-3050 Specifications

Power

voltage	120V
frequency	60Hz
current	11.5A

System Memory

standard RAM	512MB
maximum RAM	1GB
hard drive capacity	80GB

Output Speeds

warm-up time	Within 30 Seconds
first copy out time	3.9 Seconds
pages per minute (letter)	30

Weight and Dimensions

width	23.6"
depth	25.4"
height	29.3"
weight	188 lbs