Kyocera KM-3050 User Manual

FAX Operation (Basic)
OPERATION GUIDE 3-13
3
Cancelling Communication
The method for cancelling communication with this machine differs
depending on the transmission method (memory transmission or direct
transmission) and communication form. Methods of cancelling in various
cases are explained here.
Cancelling Memory Transmission (while originals are being scanned)
During memory
transmission, to
cancel scanning
while originals are
being scanned,
press the Stop key
on the operation
panel, or press
[Cancel] on the touch
panel. Scanning of
originals is canceled,
and the originals are
ejected. When
originals remain in
the document
processor, take them
out from the original
output table.
Cancelling Memory Transmission (during communication)
During memory transmission, to cancel communication after it has started
following the completed scanning of originals, use the following procedure.
NOTE: You can cancel transmission by disconnecting the telephone line.
For details, refer to Cancelling Transmission (Disconnection of
Communication) on page 3-15.
1
Press the Status/
Job Cancel key.
2
Press [Sending Jobs].
30/40/50 ppm model 25/30 ppm model
30/40/50 ppm model 25/30 ppm model

Kyocera KM-3050 Specifications

Power

voltage	120V
frequency	60Hz
current	11.5A

System Memory

standard RAM	512MB
maximum RAM	1GB
hard drive capacity	80GB

Output Speeds

warm-up time	Within 30 Seconds
first copy out time	3.9 Seconds
pages per minute (letter)	30

Weight and Dimensions

width	23.6"
depth	25.4"
height	29.3"
weight	188 lbs