Kyocera KM-3050 User Manual

Setup and Registration
6-30 OPERATION GUIDE
8
Press [Use] and use
the numeric keys to
enter the encryption
box number
(4 digits), and press
[OK].
9
Press [OK].
10
Press [OK].
11
Press the Start key. The transmission will start.
Operation at the Receiving System
To conduct encryption communication operating the receiving system,
follow the steps below.
NOTE: In encryption communication, sub address communication
cannot be used.
1
Register the encryption key you have arranged with the sending system.
(Refer to Registering an Encryption Key on page 6-27.)
2
Press the System Menu key.
3
Press [FAX/i-FAX], [Next] of Reception and [Change] of Encryption RX.
4
Press [On], select
the encryption key
number and press
[OK].
5
The sending system conducts encrypted transmission. When encryption
communication is conducted normally, the machine decrypts the
encrypted originals received and prints the originals.
Status
OK
10/10/2007 10:00
Enter box number using num eri c keys .
Cancel
Destination
Not Use
FAX No. Entry - Encryption Box
0
0002
Use
Box No.
Ready to send.
Enter Destination.
Status
FAX - Encrypt ion RX
OK
10/10/2007 10:00
Encryption key No.
Off
1/1
On
Cancel
Decrypt the received data.
Select the key to decrypt.
Key
Key
01
02

Kyocera KM-3050 Specifications

Power

voltage	120V
frequency	60Hz
current	11.5A

System Memory

standard RAM	512MB
maximum RAM	1GB
hard drive capacity	80GB

Output Speeds

warm-up time	Within 30 Seconds
first copy out time	3.9 Seconds
pages per minute (letter)	30

Weight and Dimensions

width	23.6"
depth	25.4"
height	29.3"
weight	188 lbs