Kyocera KM-3050 User Manual

FAX Operation (Basic)
OPERATION GUIDE 3-11
3
FAX Automatic Reception
When using this machine as a FAX-dedicated machine that does not
receive telephone calls, set the machine to FAX-dedicated reception. No
special operation is required when receiving faxes.
NOTE: When you are receiving DRD service from a telephone company,
change the reception method to [Auto (DRD)]. For details, refer to DRD
Reception (Available for inch versions only) on page 6-14.
Reception Method
This machine allows the following five reception methods.
• Auto (Normal)
• Auto (FAX/TEL) (Refer to page 6-2.)
• Auto (TAD) (Refer to page 6-4.)
• Auto (DRD) (Refer to page 6-14.)
• Manual (Refer to page 4-12.)
Checking and Changing the Reception Method
1
Press the System
Menu key.
2
Press [FAX/i-FAX], [Next] of Reception, [Next] of FAX, and then [Change]
of RX Setting.
3
Select [Auto (Normal)].
4
Press [OK].
5
To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Reception Starts
1
When a fax has been sent to you, the machine rings the registered number
of times, and then starts receiving the fax.
After reception has started, the Receive indicator blinks.
30/40/50 ppm model 25/30 ppm model

Kyocera KM-3050 Specifications

Power

voltage	120V
frequency	60Hz
current	11.5A

System Memory

standard RAM	512MB
maximum RAM	1GB
hard drive capacity	80GB

Output Speeds

warm-up time	Within 30 Seconds
first copy out time	3.9 Seconds
pages per minute (letter)	30

Weight and Dimensions

width	23.6"
depth	25.4"
height	29.3"
weight	188 lbs