Kyocera KM-3050 User Manual

FAX Operation (Advanced)
4-8 OPERATION GUIDE
Interrupt Send
During communication, when you scan originals by selecting direct
transmission, you can use interrupt send. Even when the communication
is prolonged due to broadcast transmission or a next transmission being
scheduled, the machine will first send originals for which interrupt send has
been set.
NOTE: When the number of standby transmissions and delayed
transmissions has already reached 200, you cannot use interrupt send.
Depending on the timing of the interruption, you may not be able to
interrupt transmission immediately.
1
Press the Send/FAX key.
2
Load the originals to be sent using Interrupt Send.
3
Press [Advanced Setup], and then [FAX Direct Transmission].
4
Press [On].
5
Press [OK].
6
Set the destination, and press the Start key. The originals are left in queue,
and the transmission will start when transmission becomes possible.
NOTE: For operation of direct transmission, refer to Selection of
Transmission Method on page 3-2.
To cancel transmission while waiting for interrupt send, press the Stop key
on the operation panel or [Cancel] on the touch panel. For details, refer to
Cancelling Communication on page 3-13.
7
When the interrupt send is completed, the canceled communication and
standby transmission will automatically resume.
Status
10/10/2007 10:00
Enter Destination.
Cancel OK
Add Shortc ut
Ready to directly transmit FAX.
OnOff
FAX Direct Transmission
Destination
Send FAX directly, without reading original
into memory. FAX can also be sent
page by page , wit h conf irm ation
af ter eac h page.
0
Press [OK] to display
the image.

Kyocera KM-3050 Specifications

Power

voltage	120V
frequency	60Hz
current	11.5A

System Memory

standard RAM	512MB
maximum RAM	1GB
hard drive capacity	80GB

Output Speeds

warm-up time	Within 30 Seconds
first copy out time	3.9 Seconds
pages per minute (letter)	30

Weight and Dimensions

width	23.6"
depth	25.4"
height	29.3"
weight	188 lbs