4. Reconnect the cables and power cords (see “Connecting the cables” on page
95).
5. Update the server configuration (see “Updating the server configuration” on
page 96).
6. Slide the server back into the rack, if necessary.
7. Start the server. Confirm that it starts correctly and recognizes the newly
installed devices, and make sure that no error LEDs are lit.
8. (Business Partners only) Complete the additional steps in “Instructions for
Business Partners” on page 25.
Replacing the air baffle
Use this information to replace the air baffle.
About this task
To replace the air baffle (if it has been removed), complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 33.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables (see “Turning off the server” on page 23).
3. Align the air baffle pins with the baffle pin holes on both sides of the chassis;
then, lower the air baffle into the server. Press the air baffle down until it is
securely seated.
Note: Close the retaining clip on each end of the DIMM connector before
installing the air baffle for proper cooling.
Chapter 2. Installing optional devices 93
To Next Page
Loading...
Need help?
General