Lenze C 750 User Manual

Address Name / seng range / [default seng] Informaon
0x2022:039 Device commands: Load TA default sengs
•
All parameter changes made by the user are lost during this process!
•
When the device command has been executed successfully, the value
0 is shown.
0 O / ready Only status feedback
1 On / start All controller parameters are reset to the default seng. Parameters
that are declared separately in the applicaon are set to the
corresponding standard values from the technology applicaon.
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Device disabled)
5.13 Start PLC program
How to start the PLC program:
Precondions
•
The »PLC Designer« is connected to the controller and the current PLC program has
already been transferred.
1.
Use the menu command Debug -->Start or the funcon key <F5> to start the PLC program.
The following table provides informaon on the current state of the PLC project.
LED status display
"RUN" LED (yellow/green) Meaning
PLC project is being loaded.
PLC project is stopped.
PLC project is started.
5.14 Generate boot applicaon
An executable PLC program can be executed when the controller is started.
To do so, a boot applicaon must have been created using the »PLC-Designer« The boot
applicaon also stores the parameter set on the SD card of the controller.
Commissioning
Start PLC program
Reset parameters to default
24

Lenze C 750 Specifications

General

Brand	Lenze
Model	C 750
Category	Controller
Language	English