Rigging work
11.8 Outrigger operation
Operating Instructions GMK5250L 3 302 633 en 11 - 51
27.09.2017
11.8.6 Moving the outrigger pads into working/driving position
H
The illustrations show one outrigger pad. The pulling direction of the other
outrigger pads may differ from this.
Moving them into working position
• (A) – Pull out the pin (1).
• (B) – Pull the outrigger pad outwards by the
handles (2).
• Secure the outrigger pad with the pin (1).
• Secure the pin (1).
• Move the other outrigger pads into operat-
ing position in the same way.
Securing pin
• Plug the pin with the peg (1) through the
cutout (2).
• Turn the grip (3) downward.
Moving into driving position
• (A) – Pull out the pin (1).
• (B) – Push the outrigger pad by the
handles (2) as far as possible back onto
the clamp (3).
• Secure the outrigger pad with the pin (1).
• Secure the pin (1).
• Move the other outrigger pads into driving
position in the same way.
To Next Page
Loading...
Need help?
General
