Crane operation
10.4 Operation of the rated capacity limiter
Operating Instructions GMK5250L 3 302 633 en 10 - 41
27.09.2017
10.4.4 Confirm the rigging mode and lifting capacity table
You must confirm the rigging mode together with the display lifting capac-
ity table before commencing crane operation. Some parts of the procedure
are different, depending on the entered slewing range type.
Standard slewing
range type
If the MAXbase slewing range type has been entered; Ã p. 10 - 43.
• Check that the current rigging mode of the truck crane corresponds to the
displayed rigging mode.
• Check:
• Correct any incorrectly entered rigging
modes if necessary.
The displayed lifting capacity table (9) applies
to the RCL code (5) in the corresponding slew-
ing range (8) and for the preselected telescope
status (7).
If the actual rigging mode is displayed cor-
rectly and the planned operation can be per-
formed within the displayed working range (8)
then you can confirm the rigging mode.
s
G
Risk of accidents due to an incorrectly set RCL!
If the current rigging mode varies from the displayed rigging mode, the
maximum load displayed by the
RCLwill not correspond to the actually
permissible lifting capacity according to the
lifting capacity table.
Overloading and accidents will certainly be the result.
–1 The slewing range for the planned
job
–2 The rigged outrigger span
–3 The rigged counterweight
–4 The rigged boom system
–6 The number of reeved hoist rope
lines
To Next Page
Loading...
Need help?
General
