Manitowoc Grove RT9150E User Manual

3-101
RT9150E OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
Published 2-23-2017, Control # 644-00
Grove
ERROR SUBMENU
The RCL Error submenu is where you access and
acknowledge any errors that are present.
Opening the Submenu
Stop all crane movements and bring both control levers into
zero position.
Press the button (2) (Figure 3-102) once. The button is only
active when the lamp (1) flashes or lights up.
Exiting the Submenu
You can exit the Error submenu at any time.
Press the button (1) (Figure 3-103) once.
The same menu opens that was open before the Error
submenu opened.
NOTE: All errors remain saved until you switch off the
ignition, even those errors of which the cause has
been eliminated in the meantime. All existing errors
are treated as new errors and displayed again after
turning on the ignition.
Error Submenu
Refer to the following section for a description of each item
listed above.
FIGURE 3-102
FIGURE 3-103
Item Description
1 Selection
2 Display of current error
3 Display of total errors
4 Error code
5 Error display
FIGURE 3-104
1
2
3
4
5
Item Description Graphic Explanation
1 Selection
You can call up all current errors with
the buttons (1) and (2).
(1) Display errors in ascending order.
(2) Display errors in descending
order.
Every time you press, the next error
will be displayed.
When you keep a button pressed, all
errors are shown one after the other
continuously.
Reference Only

Manitowoc Grove RT9150E Specifications

General

Brand	Manitowoc
Model	Grove RT9150E
Category	Construction Equipment
Language	English