Installation
*INSTALLATION*
116
Installing the oven
For safety reasons, the oven may
only be used after it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Connect the mains cable from the
oven to the electricity supply.
Do not carry the oven by the door
handle. The door can be damaged.
Use the handle cut-outs on the side
of the housing to lift the appliance.
It is a good idea to remove the door
(see "Cleaning and care - Removing
the door") and the accessories before
installing the appliance. This makes
the oven lighter when you push it into
the housing unit and you do not run
the risk of lifting it by the door handle
by mistake.
Push the oven into the housing unit
and align it.
Open the door, if you have not
removed it.
Use the screws supplied to secure
the oven to the side walls of the
housing unit.
Refit the door, if necessary (see
"Cleaning and care - Fitting the
door").
To Next Page
Loading...
Need help?
General
Weight and Dimensions
