Cleaning and care
94
Pyrolytic programme cleaning
Instead of cleaning the oven
compartment manually you can run the
Pyrolytic programme function.
During Pyrolytic cleaning the oven
compartment reaches temperatures in
excess of 400°C. Any residual soiling is
burnt off and turned to ash by the high
temperatures.
There are 3Pyrolytic settings available,
each with a different duration.
- Level 1 for light soiling
- Level 2 for heavier soiling
- Level 3 for very heavy soiling
The oven door is automatically locked
when the Pyrolytic cleaning process is
started. It cannot be opened until after
the programme has finished.
The timer can be used to delay the start
time of the Pyrolytic cleaning
programme, for instance to make use of
cheaper electricity tariffs.
At the end of the Pyrolytic cleaning
programme any residues such as ash
from the pyrolytic process, which are
formed depending on the oven
compartment’s degree of soiling, can
be easily wiped away.
Preparing for pyrolytic cleaning
Accessories that are not suitable for
pyrolytic cleaning will be damaged
by the high temperatures.
Remove all accessories that are not
suitable for pyrolytic cleaning from
the oven before starting the pyrolytic
cleaning programme. This also
applies to non-pyrolytic accessories
purchased separately to the oven.
The following accessories are suitable
for pyrolytic cleaning and can be left in
the oven compartment during pyrolytic
cleaning:
– Shelf runners
– FlexiClip telescopic runners HFC72
– Rack HBBR72
Take all non-pyrolytic accessories out
of the oven.
Place the rack on the top shelf level.
Coarse soiling in the oven
compartment can cause thick smoke
to develop.
Burnt-on residues can leave lasting
discolouration or matt patches on
enamelled surfaces.
Before starting the Pyrolytic cleaning
programme, remove coarse soiling
from the oven compartment and
scrape any burnt-on residues off
enamelled surfaces with a glass
scraper.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
