Before using for the first time
32
Heating up the oven for the
first time and rinsing the steam
injection system
When the oven is heated up for the first
time, it may give off a slight smell. This
can be eliminated by heating the empty
oven for at least one hour. It is a good
idea to rinse out the steam injection
system at the same time.
Ensure that the kitchen is well
ventilated while the appliance is being
heated up for the first time.
Prevent odours from escaping into
other rooms.
Remove any protective foil and
stickers, except the data plate, from
the oven and accessories.
Before heating the oven up, wipe the
interior with a damp cloth to remove
any dust or bits of packaging that
may have accumulated during
storage and unpacking.
Fit the FlexiClip telescopic runners to
the shelf runners and insert all trays
and the rack.
Switch the oven on with the On/Off
sensor.
The main menu will appear.
Select Oven functions.
Select Moisture Plus.
Select Moisture Plus + Fan Plus.
The recommended temperature will
appear (160°C).
The oven heating, lighting and cooling
fan will switch on.
Set the maximum possible
temperature (250°C).
Select Continue.
Select Automatic.
The prompt to draw in water appears.
Fill a suitable container with the
required amount of fresh tap water.
Open the door.
Pull the water intake pipe forwards
(located below the control panel on
the left).
Immerse the end of the water intake
pipe in the container with tap water.
Confirm with OK.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
Remove the water container after the
water intake process and close the
door.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
